Easy Machine Binding Technique

posted in: YouTube Videos | 0

We all love to piece and quilt.  Maybe one more than the other, but we rarely hear “I just love to bind the quilt.”  When it’s time to bind the quilt, we are so close, but so far away.  We have spent time and money to get this far, but we truly have nothing until the binding is on.

This post is not called “Winning Quilt in a Quilt Show Binding” for a reason.  We are going to do it by machine and you will be finished in less than 2 hours.  We piece our quilts by machine, quilt them by machine, but yet think we have to spend hours and hours stitching the binding on by hand.  Often, though, when we try machine binding, we are not satisfied with the look.  The stitching might look fine on the top side, but be off the binding on the back.  This video is meant to show you how to have your binding look the same on the front and back of the quilt.

This binding technique works great for quilts that we need to finish.  The quilts we make for kids or donations and ones we need to get finished.  Let’s get those bindings on so we can curl up under a new quilt this fall.

It’s a little hard to see my cutting chart.  I have written the measurements below so you will have it as a written reference.

Here is our latest Youtube video “Easy Machine Binding Technique”.
   We hope the video was helpful and you will give it a try. Let me go over the mathematical cutting measurements again as they are so important to your success.
1.  This is a double binding technique. Your strips will be cut selvage to selvage.  After cutting your strips, they will be seamed and then folded in half, wrong sides together. Don’t press the strips, just fold them in half. You will be sewing the raw edges of the binding to the backside of your quilt.
2.  Use a “busy” binding to hide inaccuracies. All your stitches will show on a solid.
3.  Use a thin thread such as Aurifil or DMC cotton.  Both are 50wt and thin so they will blend better.
4.  Determine the width of binding you want.  My preferred is 3/8″, but if there is piecing that goes to the edge, I use a 1/4″ so that I don’t cut off my piecing points.

5.  The math is:  6 times the width you want your binding + 1/4″ to allow for the thickness of the batting.

1/4″ binding:  6 x 1/4″ = 1 1/2″ + 1/4″ = 1 3/4″ to cut your strips
3/8″ binding:  6 x 3/8″ = 2 1/4″ + 1/4″ = 2 1/2″ to cut your strips

1/2″ binding:  6 x 1/2″ =  3″ + 1/4″ = 3 1/4″ to cut your strips

To calculate how much fabric you need for binding, consider each strip to be 40″.  You can add up the 4 sides of your quilt and divide by 40 to tell you how many strips you need.  Always round up.  Then multiple this number by the width you are cutting your strips.  This will give you the yardage.  For a throw sized quilt, 3/4yd will be plenty.  For a bed size quilt, 1 yard should do it. It’s always better to have a little extra.

You will have to figure out how to get these sewing widths on your machine so that you are actually stitching the proper width for your math calculation. Sewing your binding on with the width that you used to calculate the strip width is important.

We have the “big board” in the shop so you can come by and take a look.   Hope this will help you finish some of those quilts that just need the binding.